The fixed elevator can knock the oil pipe with a non-metallic hammer rod, either continuously or discontinuously, to facilitate the removal of attachments in the pipeline.

2、为了防止外界湿气引起锈蚀，清洗结束时，液压泵还要连续运转，直到温度恢复正常为止。固定式升降机的液压站清洗后要将回路内的清洗油排除干净。

2. In order to prevent corrosion caused by external moisture, the hydraulic pump shall operate continuously until the temperature returns to normal after cleaning. After cleaning the hydraulic station of the fixed lift, the cleaning oil in the circuit shall be drained.

3、在清洗过程中，液压泵运转和清洗介质加热同时进行。清洗油液的

3. During the cleaning process, the hydraulic pump operates and the cleaning medium is heated at the same time. Cleaning fluid

清洗固定式升降平台的液压站方法

Method for cleaning hydraulic station of fixed lifting platform

1、固定式升降平台可用非金属锤棒敲击油管，可连续地敲击，也可不连续地敲击，以利去除管路内的附着物。

1. The fixed lifting platform can be used to knock the oil pipe with non-metallic hammer and rod, which can be knocked continuously or discontinuously, so as to facilitate the removal of attachments in the pipeline.

2、为了防止外界湿气引起锈蚀，清洗结束时，液压泵还要连续运转，直到温度恢复正常为止。固定式升降机的液压站清洗后要将回路内的清洗油排除干净。

2. In order to prevent corrosion caused by external moisture, the hydraulic pump shall operate continuously until the temperature returns to normal after cleaning. After cleaning the hydraulic station of the fixed lift, the cleaning oil in the circuit shall be drained.

3、在清洗过程中，液压泵运转和清洗介质加热同时进行。清洗油液的温度为(50-80)℃时，系统内的橡胶渣是容易除掉的。

3. During the cleaning process, the hydraulic pump operates and the cleaning medium is heated at the same time. When the temperature of the cleaning oil is (50-80) ℃, the rubber slag in the system is easy to remove.

4、固定式升降平台液压泵间歇运转有利于提高清洗效果，间歇时间一般为(10-30)min。清洗时间一般为48-60小时，要根据系统的复杂程度要求和污染程度等因素决定。

4. The intermittent operation of the hydraulic pump of the fixed lifting platform is conducive to improving the cleaning effect. The intermittent time is generally (10-30) min. The cleaning time is generally 48-60 hours, which shall be determined according to the complexity requirements of the system, pollution degree and other factors.

5、在清洗油路的回路上，应装过滤器或滤网。刚开始清洗时，因杂质较多，可采用80目滤网，清洗后期改用150目以上的滤网。

5. A filter or strainer shall be installed on the circuit of the cleaning oil circuit. At the beginning of cleaning, due to the large amount of impurities, 80 mesh filter screen can be used. At the later stage of cleaning, filter screen with more than 150 mesh can be used.

以上就是为大家介绍的升降货梯厂家http://www.crrpsc.cn有关的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务.

The above is the elevator manufacturer introduced to you http://www.crrpsc.cn I hope that the detailed introduction to the will be helpful to you If you have any questions, please contact us We will provide you with professional service